Question about SSRs

[mortal meerkat]

I want to know if 14" mk series wheels will fit over 1.8 brakes. Im trying to decide whether or not Im going to sell my 13" DRWs and if the SSRs fit over 1.8 brakes I will have no need for my steelies. So any help would be appreciated. Thanks in advance guys

[hooligan]

are you missing the MK1,2,3 or mesh etc as you just state MK?

also depends on the offset as well, i had a set of mesh on mine with 1.8 brakes 14x6.5 et26

i think if you had a low offset set you would struggle to clear 1.8 brakes

[mortal meerkat]

more specifically mkIs in 14x9 ET0

[Coupeloop]

IIRC...no, regardless of offset and width, it wont fit. I think the MK1-2-3 series are practically 0 disk?
Mike has a set of 14s on his car, and went from 1.8 to 1.6 brakes just to use his MKIIs

[mortal meerkat]

well i know harry from slamburglars is running 13x8 mkIIs in the front and 13x7.5 mkIIIs in the rear with 1.8 brakes but he has to run spacers.

[Coupeloop]

yes, there is a certain part of the inner barrel that comes up and rubs. even on the 1.6 brakes... I would know. I imported those wheels over here.

[mortal meerkat]

meh, looks like ill have to run spacers. thanks man

[Roadster]

IIRC...no, regardless of offset and width, it wont fit. I think the MK1-2-3 series are practically 0 disk?
Mike has a set of 14s on his car, and went from 1.8 to 1.6 brakes just to use his MKIIs

If you mean me, then yes I switched over to the 1.6 brakes and even machined the knuckles on the calipers to make them fit properly.
Of course you could always use wheel spacers

[mortal meerkat]

yeah, im pretty sure i wont need anything more than a 10mm spacer so im not too worried about it