TheFrohn
01-20-2012, 03:43 PM
Hey everyone... noob here at installing steering wheels.
My set up is:
NRG Short Hub
NRG Quick Release 2.5
Nardi Deep Corn 330 mm wheel.
Going into my 2005 Mazdaspeed Miata.
Pulled off the stock wheel from the MSM this afternoon.
I had known from doing some research that the conductive plate on the back of the hub needed to be removed.
So I did so which freed up room behind the hub.
However the hub still wont fit over the connectors for the airbag and horn.
Wondering how others with this set up over came this issue?
Can the plastic be trimmed down without compromising the connections?
Any help would be appreciated, thanks!
Pardon the crappy cell phone pics.
http://i25.photobucket.com/albums/c68/Thefrohn/sw1.jpg
http://i25.photobucket.com/albums/c68/Thefrohn/sw3.jpg
My set up is:
NRG Short Hub
NRG Quick Release 2.5
Nardi Deep Corn 330 mm wheel.
Going into my 2005 Mazdaspeed Miata.
Pulled off the stock wheel from the MSM this afternoon.
I had known from doing some research that the conductive plate on the back of the hub needed to be removed.
So I did so which freed up room behind the hub.
However the hub still wont fit over the connectors for the airbag and horn.
Wondering how others with this set up over came this issue?
Can the plastic be trimmed down without compromising the connections?
Any help would be appreciated, thanks!
Pardon the crappy cell phone pics.
http://i25.photobucket.com/albums/c68/Thefrohn/sw1.jpg
http://i25.photobucket.com/albums/c68/Thefrohn/sw3.jpg