rare seats!
Printable View
rare seats!
EuNOs DRivEr OpTioN SEaTS!
My supposed low mileage Miata 5 speed transmission that I bought for my Ecotec swap shifts poorly unless rpm matched. At a stand still it is hard to get in gear. It acts like the input shaft is spinning even when the clutch is depressed. The clutch slave has adequate travel and the clutch engagement point seems spot on. So it is either a factor of the engine/transmission adapter or I have a bad transmission.
So I am now moving ahead with accumulating parts to install an AR5 transmission that would eliminate the adapter and bring the drive-train back to a similar mechanical configuration as a Pontiac Solstice.
I have bought two almost new AR5 transmissions One a factory take-out and the other with 40 miles from a Polaris Slingshot. (Can you believe there is a shop that converts the Slingshot to an automatic?)
https://i.ebayimg.com/images/g/Ka4AA...0O/s-l1600.jpg
I also bought a new flywheel, new pilot bearing, new flywheel bolts, new starter, new mounts, and a new driveshaft. I still need engine/transmission bolts, clutch assembly, and clutch plate bolts.
https://i.ebayimg.com/images/g/E-MAA...9p/s-l1600.jpg
Ecotecmiata is developing a kit to adapt the Miata PPF to this transmission.
I will probably install it next summer.
For me the good news is that my driver 1979 Thunderbird is finished so all it needs is light maintenance over the next few years. My wife's 1976 Mustang II should be completed over the winter. So next summer should be Miataville time.
Been tempted by one of these myself for the track days. I'd probably glass it into a spare lid so there's no seams. Ugh, money.Quote:
Originally Posted by Phatmiata
I cant wait to see this installed.Quote:
Originally Posted by Phatmiata
EDO seats FTW!Quote:
Originally Posted by vote4pedro
Not today, but last Thursday, I went for a drive searching for twisty roads <3
https://i.imgur.com/6pmKqBS.jpg
https://i.imgur.com/dy68cu1.jpg
Hardtop
Nakamae Door Panels
KAROism mats
Will update with pics in a 2019 thread once the items are “in hand”