What did you do to your NA today 2012?

[—Martin—]

I attempted to install my revlimiter window switches. Too much wiring for it to fit with my Nakamae console, so back to the OEM switches for now.

[akilli89]

I drove it after two terrible days of it not moving or getting any attention at all.

[pork n beanz]

Installed my project g vented side windows looks sharp

[iKhanh]

pictures or it didn't happen!

[iKhanh]

lowered the car even more yesterday; now the tires are just barely covered by the fenders. today.... i just noticed how much more rear camber i have. maaaaan.

[miatattitude]

New CAS oring...installed fairly quick.

[akilli89]

OEM or aftermarket?

[★ garageSTAR ★]

Finished up the majority of the exterior. Going to add all the badges on later this week.



Not finished with the interior but polished up my Garage Star seat rails yesterday.

[— Willywongka —]

Look'n good Ken! Can't wait to see it in person this coming Saturday.

As for me, I recently fitted a Momo retro 360mm steering wheel.

Until I finally figure out how to fit my other horn button, that current button as well as that ring will stay.

[bedheadben]

Finished up the majority of the exterior. Going to add all the badges on later this week.
Not finished with the interior but polished up my Garage Star seat rails yesterday.

Very nice! When am I gonna get a chance to see this thing? Maybe a NorCal cruise?

As for me, I recently fitted a Momo retro 360mm steering wheel.

Until I finally figure out how to fit my other horn button, that current button as well as that ring will stay.

Those gauges are HAWT!

[HungryR]

I changed the water pump inlet oring. It was so hard to take the bolts off even with liquid wrench.
Took off everything except 2 and broke 1 head. I had to bend the heatshield back to unbolt the inlet pipe. everything was put together properly in the end and thank god that there is no more water leak...

So far I have changed just on the coolant system alone: water pump/ tbelt/ radiator/ thermostat /main hoses/ all auxillary hoses(4) / passenger side heater line / and now inlet oring...

[HungryR]

New CAS oring...installed fairly quick.

It took me 2 hours to put mine back in... I was about to remove the valve cover, but it finally went it...

[mike92miata]

Finished install of "winter" motor & tranny helped my friend finish his motor swap in his NA.

[psulja]

Last week put the new wheels on, pulled the fenders a bit, raised the ride height a bit, washed it, and then went out for a photoshoot with a friend.

[The Driver]

Last week put the new wheels on, pulled the fenders a bit, raised the ride height a bit, washed it, and then went out for a photoshoot with a friend.

Pics, or it didn't happened...