no, the NB1 door frame inner structure is a little different, and so the door handles are about 1.5 inches forward of the NB2 ones.
no, the NB1 door frame inner structure is a little different, and so the door handles are about 1.5 inches forward of the NB2 ones.
Phatmiata (09-17-2015)
Liking the refresh! Im taking notes on your semi-V setup! Could free up some air flow on my 30 piece cooling stack up from the rotrex and junk
Needed something to roll on while I build my 2-way dampers so I dusted these out. Basically the last project I was involved in before leaving TEIN was the development of the new Monosport coilovers. 6 months of canyon, daily driving, track and drift events to try and find the best balance between everything.
TEIN Monoflex base
2nd Generation MSV (Micro speed Valve) better and more consistent control of low speed valving compared to the 1st gen system
Advance Needle retrofit, bypass ported from 2mm>4mm allowing a 200% increase of adjustability. Wouldnt be possible without MSV gen 2
TEIN Rally Oil and Dust Seals, higher heat capacity with a severe decrease in friction co-efficient
TEIN Rally Oil, Higher heat capacity before aeration
Swift Sprangs
just about finished the main structural reinforcements apart from seam welding.
I know some, maybe a lot of ya'll gonna hate this but.
bye bye MSM Door cards
Might have to wait a bit longer on that. I've been convinced to get the car BAR'ed and get that sticker before I resume the upgrade party.Originally Posted by artcentermiata
fwdtamiya (09-17-2015)
Not gonna keep the TEINs??
not for long, im working on other set-ups so im constantly trying and revising different dampers.
The door card looks good! just needs some smoothing of the edges
you guys wanna see a pain in the dick? i'll show u a pain in the dick.
Demon I Am (09-23-2015),HarryB (09-22-2015),tsingson (09-22-2015)
How long did this actually take?
I started after work at 6. Finished bolting up the Garage Star Frame Rails 8, got that far by 12:30? Unfortunately I remembered I hadn't swapped the vin plates so I need to do that before finishing
f1 spec flywheel just got back from the machine shop. resurfaced and balanced and good to go
front interior is in along with the front harnesses
I thought you got rid of this car, glad to be wrong
it just sat around for the longest time inside the garage only driven to track events.
went from old man tan to
and installed the canvas top...
Agent☣Orange (12-30-2015)
Posting Permissions
Reply With Quote
