OK, since the plans have changed for the 23422 time, I'm most likely driving this Miata until it's a "Classic". Time to make it my own!

I've had these Boss Frog Frog Arms for a few years now. They look lovely hanging up on my garage wall! I think it's time to toughen up and get them installed. I've been hesitant because modifying a car when I know it's going to be sold just felt weird, and MOST IMPORTANTLY, I'm afraid to remove the large Tupperware skirts.

I know where popular opinion lies with the skirts, but I'm not popular, and I'm old enough to not care about what others' opinions are on the aesthetics of my car. That said, I have not found much information regarding the removal. I know there are holes in the rear QP that hold a snap bolt. I'm sure there's a far share of double-side tape or weather strip goo to remove. I know the skirts are mounted on a metal rail that they clip onto. And that's about it.

So what I want to know before I get started is...

Is removal as simple as unbolt the bottom, yank the snap bolt from the body hole, then carefully peel it off?

What should I use for re-install? Double-stick foam tape? "Window goo"? Obviously, I want to make sure it's sealed enough to not cause issues (rust, road debris buildup)

Anything else I should do with the front fenders removed? I'm thinking that it's a good time to install side winkers, and refinish or replace the hazy, ugly headlights. This is a project I do not want to re-do.