Results 1 to 6 of 6

Thread: NA Cluster question

  1. #1
    2,000 rpm - light wheelspin, no bog here! Boo's Avatar
    Drives
    NA Miata
    Location
    Massachusetts
    Join Date
    Dec 2017
    Posts
    318
    Thanks Given
    62
    Thanked 29 Times in 21 Posts

    NA Cluster question

    I just put a 1992 Miata Cluster in my 1995, I put all new gauges from Rev Limiter, all the gauges work good except for the oil pressure, when I shut the car off it’s on zero, when I put the key on the on position it goes to about 40 psi but when I start the engine it goes back to zero psi, any one have any ideas?

  2. #2
    Admin / Pit Boss / Miataholic Phatmiata's Avatar
    Drives
    Kirin the '93LE Roadster #1073
    Location
    NEW Tampa > OLD Tampa
    Join Date
    Apr 1994
    Posts
    33,605
    Thanks Given
    13,678
    Thanked 9,518 Times in 4,641 Posts
    95 had a dummy oil gauge. Take the oil gauge out of your 95 cluster and put it into the cluster you are using in the car.

  3. #3
    2,000 rpm - light wheelspin, no bog here! Boo's Avatar
    Drives
    NA Miata
    Location
    Massachusetts
    Join Date
    Dec 2017
    Posts
    318
    Thanks Given
    62
    Thanked 29 Times in 21 Posts
    Thank you, is it a hard job to remove the gauge, or am I better off getting another cluster for a 1995?

  4. #4
    Admin / Pit Boss / Miataholic Phatmiata's Avatar
    Drives
    Kirin the '93LE Roadster #1073
    Location
    NEW Tampa > OLD Tampa
    Join Date
    Apr 1994
    Posts
    33,605
    Thanks Given
    13,678
    Thanked 9,518 Times in 4,641 Posts
    2 or 3 screws if I remember correctly, if you can install or remove a cluster this should be no sweat

  5. The Following User Says Thank You to Phatmiata For This Useful Post:

    Boo (09-22-2018)

  6. #5
    2,000 rpm - light wheelspin, no bog here! Boo's Avatar
    Drives
    NA Miata
    Location
    Massachusetts
    Join Date
    Dec 2017
    Posts
    318
    Thanks Given
    62
    Thanked 29 Times in 21 Posts
    Thank you for the info

  7. #6
    Mod Squad
    Drives
    2016 Ceramic GT
    Location
    Bentonville, Arkansas
    Join Date
    Dec 2011
    Posts
    9,294
    Thanks Given
    2,074
    Thanked 2,451 Times in 1,353 Posts
    Or replace the sender with one from a 90-94 and have a real working gauge.

  8. The Following User Says Thank You to Martin For This Useful Post:

    Boo (09-22-2018)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •