-
2,000 rpm - light wheelspin, no bog here!
NA Cluster question
I just put a 1992 Miata Cluster in my 1995, I put all new gauges from Rev Limiter, all the gauges work good except for the oil pressure, when I shut the car off its on zero, when I put the key on the on position it goes to about 40 psi but when I start the engine it goes back to zero psi, any one have any ideas?
-
-
95 had a dummy oil gauge. Take the oil gauge out of your 95 cluster and put it into the cluster you are using in the car.
-
-
2,000 rpm - light wheelspin, no bog here!
Thank you, is it a hard job to remove the gauge, or am I better off getting another cluster for a 1995?
-
-
2 or 3 screws if I remember correctly, if you can install or remove a cluster this should be no sweat
-
The Following User Says Thank You to Phatmiata For This Useful Post:
-
2,000 rpm - light wheelspin, no bog here!
-
-
Mod Squad
Or replace the sender with one from a 90-94 and have a real working gauge.
-
The Following User Says Thank You to Martin For This Useful Post:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules