RetroModern Product: Dimmer Switch Diamond Knurled Knob Overlay - NA

[RetroModern]

unfortunately there is very little room to work with in that area so the tolerances are a tight. on my first one, i had to shave the bezel a bit to get the knob to rotate freely. I had to make the overlay a bit thinner to compensate. the thickness is .7mm +/-.01. the knurls added another .1mm. Making them by hand was a pain but so worth it.

[ezmfne]

I will be doing 5 more pieces with polished bands as a special request this week. Place your order and ill include it in the production run.

I want 2 with polished bands if it's not too late

[Demon I Am]

I followed DemonIAm's quick ten-step. It took me about an hour to sand, and I sanded it just barely enough so I had to use a block to press the new knurling over the old tab. Super tight.

I love this! Thanks RetroModern/Ken!

With a dremel and a sanding drum, it took maybe 5 minutes. All installed and happy

[—RuckkehrMiata—]

I don't have a dremel anymore, I ended up using some drywall sandpaper to take most of the content off (by hand) and then some super fine grit jewelry sandpaper to finish it.

[RetroModern]

I want 2 with polished bands if it's not too late

no, not at all. i can make the extra 2.

[ezmfne]

no, not at all. i can make the extra 2.

cool
just send an invoice when they are done
ezmfne@comcast.net
thanx again
E

[RetroModern]

Ive made a few more and updated the site to reflect the new stock.

[drv2fst]

Got mine yesterday (with HVAC knobs and lighter plug), they look great. Hope to get time this weekend to install.

[ezmfne]

cool
just send an invoice when they are done
ezmfne@comcast.net
thanx again
E

I`m having trouble using your site to order
please invoice me
I need 2 with polished bands
thanx

[RetroModern]

you should be good to go now.

[ezmfne]

yep
all good
thanx for the fix

[RetroModern]

no prob. i got your order Eric.