*continuing on from the above post*
So as mentioned before, the metal shroud covering the fuel lines fouled on the BeatRush strut bar so I decided to cut away at a section to make it fit. It also had a few bits of surface rust here and there too so I figured I'd sand and dremel it off and give the whole shroud a black paintjob.
Marked up and ready to be cut.
Cut section. Had to trial an error and cut bits away until eventually it cleared without fouling.
Scrap.
Sanded bits of the surface rust.
Same can of satin black I used on my wiper blades.
6 light coats with 2 thicker coats of black.
Result.
Installed.
Didn't bother with the carpet as I think it looks good as is. Might put it back in later but for now, pretty happy with how everything turned out
Reply With Quote