This has been in the pipeline for a while - custom machined trim rings for my Retro window switches. They were lovingly made by RetroModern and look just fantastic. I finally have my order in hand and can offer them in this group buy.
They're extremely pretty. They really give a nice look to the window switch once installed. If you look closely, you can see that there's an internal taper on the nut to match the angle of the toggle switch. They're very lovely.
They work with my Retro Hazard Switch also, but they're not recommended. The nut hides some of the DOWN label text and a lot of the hazard switch label. However, they will thread onto the hazard switches if you'd like to make them work.
And for that matter, they will thread onto any 15/16-32 threaded toggle switch. It's a fairly common switch thread size, so you should be able to source toggles to fit if you'd like to do your own switch panel.
What You Get
- A pair of the trim rings. That's two! Enough for one window switch.
- A pair of teflon washers. This goes between the switch plate and the trim ring to prevent scratches.
- Stickers and Domo-kun toys and other goodies.
All this for $15 per pair plus shipping.
Shipping in the US will be a small Priority mail box for $6. If you'd like to order some other stuff, it can most likely fit in that small box. And if you'd like to order a set of switches to go with the trim rings, I can install them for you.
You can either fill out the order form on my store site (pick Some other product from the dropbox) or you can email me: adam at revlimiter dot net.
OR you can just send me a paypal for the $21 if you really want. My paypal address is revlimiter@gmail.com
Reply With Quote
Originally Posted by Legendary
OK, if want to know how I did the dash in Project Ronin. . .you can find the basics 