-
Stalled - Fire it up!
NB1 head to manifold stud thread size?
I recently put a RB header, RB midpipe and GWR Roadster Sport II muffler on my car. During the removal of the stock California emissions exhaust manifold (man its a heavy SOB) one of the studs came out with the nut. I attempted to just reinstall it like it was a bolt as I did not have access to a new stud and nut at the time. Unfortunately I mucked up the first few threads. They're just kind roughed up. In conclusion I would like to clean up the threads for the installation of a new stud. What is the thread pitch of the manifold studs? Sorry if this has been asked before. My quick search of the forum and Google didn't turn up results.
-
-
I did the same thing on my 96 when I installed a JR header. But I used a second bolt on the first to help get the stud back in. Lucky for me it all went back on okay. I used some loctite on the threads so it would not back out again.
Unfortunately I don't remember the size or thread pitch it was so long ago.
-
-
2,000 rpm - light wheelspin, no bog here!
M10-1.25 x 45mm long Mazda genuine parts # BP8J-10-104
-
The Following User Says Thank You to Satisaii For This Useful Post:
-
4,000 rpm - entering the fun zone
You can find bolt re-threaders at Sears in the tool section for about $20.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules