The GS blocks seem to have reduced the 65mph shake in my car. It isn't completely gone but it's less noticable.
Phatmiata (07-25-2015)
Just installed mine, about to take my first test drive. Initial impressions are that the doors close VERY solidly, I can't simply swing them shut like I used to. Easy install as well. Let's hope they wear in just a bit, as closing the door is a bit of a pain at the moment. I may have to readjust them, but I installed them hand tight before opening and closing the door a few times, then snugged them down. Test drive data coming later this evening! These are on my 37k mile mazdaspeed with only a hdhcdd as additional bracing, so it should be a good test on a low mile car that suffers from the 65mph shimmy (my nemesis)
Airbrush, you might need to hit the corners with a file or some sand paper to make them slightly easier to shut.
Airbrush1 (07-25-2015)
I will consider doing that! I'm incredibly impressed after my first drive, no more squeaks and rattles at all, and the 65mph shimmy I had is all but eliminated! The car feels much stiffer, even my wife noticed an improvement! Best 65 dollars spent on the car so far! And the garage star sticker looks great on my roll bar
JLBMX5 (08-03-2015)
I was thinking that I might snap a bolt as I was tightening mine so I stopped when I thought it was tight enough I know I could of went tighter but it would of snapped for sure.
My build thread: http://mazdaroadster.net/showthread....064#post146064
Two minute remove old and install new per side. Closed and opened the door 5 times with the screws snug tight. Then tightened up good with wrench.
Car rides nice. I noticed the doors when driving don't move or make noise.
I previously added the flyin miata frame rail and butterfly so the chassis was stiff. This garage star mod made the doors now an integral part of the structure instead of just being hung on to the body.
The tighter tolerance.makes the car nicer to drive.
Btw never any issue closing the doors at all.
Last edited by JBsC6; 08-05-2015 at 08:53 AM.
are they alloy bolts? maybe upgrade to stainless, or heat treated