damn, i have some knowledge with circuit boards and stuff, but this looks a little past my level
damn, i have some knowledge with circuit boards and stuff, but this looks a little past my level
My post dissapeared
More parts hoarding. I found a Skunk2 knockoff intake manifold for a b18 on ebay for $70 because there were some messed up machining marks near the flange. Big deal. I need to cut it off anyways. This mod has been shown to be very beneficial on a boosted car.
Here are the defects
The internal casting is not bad for a knock off
As you can see the runners are pretty close to the miata intake manifold gasket I have.
For a throttle body I plan to mod it to accept the Volvo 960 64mm throttle body. Need to figure out what idle valve I am going to use. Probably going to use the volvo one I have been running.
1996 Montego Blue: Homebrew M62 Supercharger, MS2, rx7 460's, Tein Flex 9/6, 15x8 6ULs
http://mazdaroadster.net/showthread....upercharged-NA
1993 Volvo 940: b230ft with 16v, MS2, 57 Trim T3/T4, Yoshifab Intake Manifold, Ebay Intercooler , 3" Exhaust, Cut Springs
1996 Montego Blue: Homebrew M62 Supercharger, MS2, rx7 460's, Tein Flex 9/6, 15x8 6ULs
http://mazdaroadster.net/showthread....upercharged-NA
1993 Volvo 940: b230ft with 16v, MS2, 57 Trim T3/T4, Yoshifab Intake Manifold, Ebay Intercooler , 3" Exhaust, Cut Springs