Demon I Am
04-25-2015, 09:12 PM
OK, so I followed Revlimiter's Daikei hub install for my 2000 Miata. Everything went swimmingly, minus the following 2 problems:
1: The Sparco horn has 2 connectors on the back, but the horn wiring only has one. When I connect the wiring harness (that came with the hub) to either of the button's connections, I get no horn sound. If that wire is connected to the tab on the hub ring adaptor, the horn sounds nonstop. Do I need to make a jumper wire to "complete the circuit", or am I going to have to find a 1-wire horn?
2: Once I took the car for a ride, I noticed that the wheel is not set up evenly. with the car rolling straight, the wheel is in the 11:30 position instead of 12:00, as it should be. How can this be adjusted? the steering column has 2 knobs that needed to be aligned with 2 slots in the hub. I figured that there should be no way to screw this up, but it is.
Please and thanks for maximum helping satisfractions.
1: The Sparco horn has 2 connectors on the back, but the horn wiring only has one. When I connect the wiring harness (that came with the hub) to either of the button's connections, I get no horn sound. If that wire is connected to the tab on the hub ring adaptor, the horn sounds nonstop. Do I need to make a jumper wire to "complete the circuit", or am I going to have to find a 1-wire horn?
2: Once I took the car for a ride, I noticed that the wheel is not set up evenly. with the car rolling straight, the wheel is in the 11:30 position instead of 12:00, as it should be. How can this be adjusted? the steering column has 2 knobs that needed to be aligned with 2 slots in the hub. I figured that there should be no way to screw this up, but it is.
Please and thanks for maximum helping satisfractions.