kung fu jesus
03-03-2018, 05:34 PM
My drivers door isn’t closing tight enough. I can see it sticks out beyond the rear quarter at the bottom. Looking at the shot lines, you can see it:
https://uploads.tapatalk-cdn.com/20180303/dd4e01f09c7867c1a5be513086e2e7e9.jpg
https://uploads.tapatalk-cdn.com/20180303/afec3562b3dd066f5bdfb9fca5611cff.jpg
https://uploads.tapatalk-cdn.com/20180303/c4f3a6f3339b815358c63e4b6c588fc0.jpg
I can hear an air leak from this area at speed. The weatherstrip looks ok. I have tried adjusting the latch catch loop on the jamb, the rubber bushing at the bottom (even tried removing it), with little or no change.
I can push the door in a few millimeters after closing. The door “bobbles” when a shut it, like it’s stopping short of where it should land.
Does anyone have any suggestions or experience correcting this?
Thanks for reading!
https://uploads.tapatalk-cdn.com/20180303/dd4e01f09c7867c1a5be513086e2e7e9.jpg
https://uploads.tapatalk-cdn.com/20180303/afec3562b3dd066f5bdfb9fca5611cff.jpg
https://uploads.tapatalk-cdn.com/20180303/c4f3a6f3339b815358c63e4b6c588fc0.jpg
I can hear an air leak from this area at speed. The weatherstrip looks ok. I have tried adjusting the latch catch loop on the jamb, the rubber bushing at the bottom (even tried removing it), with little or no change.
I can push the door in a few millimeters after closing. The door “bobbles” when a shut it, like it’s stopping short of where it should land.
Does anyone have any suggestions or experience correcting this?
Thanks for reading!