*continuing on from the above post*
So as mentioned before, the metal shroud covering the fuel lines fouled on the BeatRush strut bar so I decided to cut away at a section to make it fit. It also had a few bits of surface rust here and there too so I figured I'd sand and dremel it off and give the whole shroud a black paintjob.
Marked up and ready to be cut.
https://farm5.staticflickr.com/4290/...161dc43c_o.jpg
Cut section. Had to trial an error and cut bits away until eventually it cleared without fouling.
https://farm5.staticflickr.com/4255/...f865431b_o.jpg
Scrap.
https://farm5.staticflickr.com/4262/...b99b1b7a_o.jpg
Sanded bits of the surface rust.
https://farm5.staticflickr.com/4207/...4ecebb82_o.jpg
Same can of satin black I used on my wiper blades.
https://farm5.staticflickr.com/4258/...8afd0ebf_o.jpg
6 light coats with 2 thicker coats of black.
https://farm5.staticflickr.com/4230/...34e92d65_o.jpg
Result.
https://farm5.staticflickr.com/4232/...125da6c1_o.jpg
Installed.
https://farm5.staticflickr.com/4239/...a6124157_o.jpg
Didn't bother with the carpet as I think it looks good as is. Might put it back in later but for now, pretty happy with how everything turned out :)