Installed my new RS-Products gauge panel!
Installed my new RS-Products gauge panel!
"My For Sale Items"
"My 2014 Club"
1994 Laguna Blue - (Runabout)
2005 BM MSM #751 of 1428 - someone else is playing with her now
"Nardi Steering Wheel Restore"
91 SD Italia
Phatmiata (06-03-2014)
As you wish! Excuse the crappy cell phone pic, I don't have a fancy smancy camera :/
Last edited by WASABI; 06-03-2014 at 09:41 AM.
Yesterday I purchased a suction cup camera mound and was attempting to mound it on the inside of the windshield. I got it stuck okay, but I couldn't get the Digital camera to point out level so I tried adding the extended arm, which required me to unscrew an allen locking bolt. I dropped the allen tool and it landed under the drivers seat between the rails and drive tunnel. I just recently purchased 2014 MX-5 so everything is pristine. I can't tell you how many times I've had to retrive at tool, or other object from under a seat. With my left hand I grabbed the allen wrench and as I pulled out my hand I cut the back of my hand on the razor sharp edge of the seat rail, nicking a blood vessel. When I saw my hand pumping blood in little squirts all over the plastic floor mats I was upset at myself for spilling my blood on the floor of my brand new Miata. I went to the ER because I could stop bleeding where they super glue the ¼ inch cut closed. When they asked who it happened I told the ER Doc, my Miata bite me!
Thats what my NC did to me.
Put all these pipes in
Why no intercooler?
Paul | IG- @psulja
Build thread:
1991 Mariner Blue - Built 1.8 swap, EFR, Fab9Tuning, Tii drivetrain
I sanded the valve cover more yesterday...FEAR MY AWESOME OIL CAP AND SCRATCHED VALVE COVER!!!!
Last edited by WASABI; 06-05-2014 at 11:39 AM.
"My For Sale Items"
"My 2014 Club"
1994 Laguna Blue - (Runabout)
2005 BM MSM #751 of 1428 - someone else is playing with her now
"Nardi Steering Wheel Restore"
91 SD Italia
That looks awesome! I like it!
6-4-14 1624.jpg 6-4-14 1626.jpg 6-4-14 1625.jpg
And here they are!
96 Montego, replacing a 95M... I miss: My running peeps in Tampa, running barefoot @ Clearwater Beach and First Choice BBQ, in Brandon. In So Cal I miss: The Malibu Canyons, CA 33 and In & Out Burgers ! I'm from Tampa, if I was from Tampa Bay, I'd be a fish!
Took out the exhaust, cat-back, now waiting impatiently for UPS to deliver my Borla!
its not scratched its hand machined... thats what I tell myself.
I fitted a duel feed fuel rail is preparation for boost and only 2 things went wrong! One fuel hose had a leak so when I turned the car over I had a nice jet of fuel aimed right up into the air not the end of the world as all I had to do was chop off 2.5cm's of hose. Looking at the marks the hole was made when me and the past owner pulled the hose off. Oh but the 2nd f**k up was totally on me... I stepped on and snapped the PCV valve so now I'm stuck till I can get another. I did start the car just by blocking the hose and all seemed fine but I wont be driving with oil vapor wafting around the car.