What did you do to your NA today 2012?

[bedheadben]

They turned me down too before I even walked into the building they told me "that wont get on the rack" lol, but I asked anyways. Went to a few local shops, Goodyear and Firestone. I think I'm going to have to get a local guy to do it and possibly corner balance it. We'll see I need to do smog this week to soo..yea lol.

My friend Greg was saying there was a goodyear up by his place that might be able to do it so I'll check that location too.

That's too bad. Any shop that does corner balancing and has an alignment rack should put your car on the rack. Do they not believe that you can get it on there with some 2x4's or what? Just because it drags/gets hung up doesn't mean it won't make it haha, sometimes you just need a little speed haha. Send me a PM if you struggle to pass smog.

[Conundrum]

That's too bad. Any shop that does corner balancing and has an alignment rack should put your car on the rack. Do they not believe that you can get it on there with some 2x4's or what? Just because it drags/gets hung up doesn't mean it won't make it haha, sometimes you just need a little speed haha. Send me a PM if you struggle to pass smog.

Yea idk they're just being up tight about it. There where a couple I knew I could get up with some 2x4's but they wouldn't allow it so that's that. A friend told me about another alignment place that has a rack kinda like the one you posted with your car on it. Going to stop by and check it out tomorrow. I appreciate the help man.

[WASABI]

Yesterday, replaced my DIY four wire oxygen sensor retro fit, with a stock one wire sensor, as I would throw engine codes: 15 and 17 daily with the four wire version. I removed my Touge Run front lip, to paint & reinstall with stainless steel hardware. I also reinstalled my under tray, after I dusted my engine bay...let's hope this helps keep her a little cleaner.

[titch]

Swapped my non-locking aerocatches for locking ones. And cleaned the bay a little bit.

[bedheadben]

Swapped my non-locking aerocatches for locking ones. And cleaned the bay a little bit.

Pics?

[titch]

I forgot that part.

Tomorrow.

[GripFTW]

Cleaned up the ignition switch to get rid of the click/no start, wait, start condition that popped up recently.

[room42]

Installed a TDR header blanket - the hood is now cool to the touch after a 25 minute drive - more testing tomorrow!

[Conundrum]

Re adjusted my ride height a bit in the rear. I had a slight reverse rake going on.

[iRoadster]

Did a little sliding around in the rain earlier. My car's filthy now.

[Graeter]

Put in the 5 point harnesses and the rally sport seats!

[KAL]

Kinda polished it, and kinda took off the luggage rack.

[JTninja]

Cleaned up the ignition switch to get rid of the click/no start, wait, start condition that popped up recently.

Interesting, Ive had a similar issue for a while now. No issues now?

[GripFTW]

Interesting, Ive had a similar issue for a while now. No issues now?

No issues so far. It is so easy and quick to do that it is a great place to start troubleshooting. Nice to have a simple fix once in a while.

Once I got the switch apart I thought it looked ok but once I started cleaning it up I wondered how it managed to start. Careful opening the housing once it's out. It is really easy to lose the tiny springs in there.

[★ garageSTAR ★]

Garage Star 1.6 carbon plug covers are back in stock so I installed one on my new Roadster.