FullSizeRender(1).jpgFullSizeRender(2).jpgFullSizeRender.jpg
Searching didn't find this issue.

As you can see in the attached pictures I broke off the captured nut in the windshield header. This is where the top receiver bolt goes in.

I must have had it a bit sideways and when I applied more pressure it broke. I can cut the head off with a Dremel, but can't access the inside of the header.

Cold I just cut out a finger sized hole so I can reach in and retrieve the nut, and then use a K-Lock nut and hope I can get it tight?