Re-drilling a wheel. Not seen this done before. Thoughts...

[— Madaboutmx5s —]

Anyone seen a PCD changed on a wheel like this before.

[horribleR]

yep

[— Madaboutmx5s —]

Thoughts

[Demon I Am]

Too much room for error, in my mind

[— Madaboutmx5s —]

Yeah for sale here in the UK. Some nice sizes but not seen wheels have the PCD pattern altered like that before.

[Stealth97]

I personally don't like it, but understand many have done it without ill effects. Technically if they are hubcentric they should be fine, but unless they were a wheel I just had to have, and they were rare I'd pass.

[wannafbody]

I'd think the correct way to do that would be to weld the hole closed and redrill.

[— kung fu jesus —]

That is sketchy as hell.

[★ revlimiter ★]

Seen it.

The "correct" way to do it is a fill and drill. You fill the hole and then drill a new one. But even that is a bit sketchy.

[horribleR]

Thoughts

10/10 would not buy. +3 sketchy.

[— Madaboutmx5s —]

Thanks all. Saw them for sale and liked the sizes of the wheels but seeing this photo was not what I had seen done before. Based on the feedback I give them a miss and won't make an offer.