Here the best window guide/bushing: http://www.ebay.com/itm/200568833934 Most of the ones you find on the web are plastic, this is cnc machined piece. Undestructable!
Here the best window guide/bushing: http://www.ebay.com/itm/200568833934 Most of the ones you find on the web are plastic, this is cnc machined piece. Undestructable!
You might want to look at my window guides...
Teflon impregnated Delrin is used in very high grade dry bearing surfaces. Read my write up.
http://roadstertech.net/Our-Products...des/index.php/
Aluminum will not last once the lubricant wears off...
Aluminum on Steel is not a good bearing surface... Aluminum always looses to steel.
You can hit a Delirn part with a hammer and not leave a mark. It runs for years in the packaging industry as a machined gear surface on delrin to steel no lube gear sets. That is for large bottle fillers with 8 foot diameter rotating bowls. Aluminum would self destruct there. And Teflon impregnated Delrin has an even better friction coefficient. I know I used to be a staff research engineer for the bottling industry and I machine aluminum, delrin and HDPE on a daily basis....
Last edited by RoadsterTech; 07-14-2014 at 09:55 AM.
You may know me as RAB or BCT or Rick depends on where you look.
Anyone that is interested in a written instruction sheet can find them here:
http://roadstertech.net/window-guide-instructions/
You may know me as RAB or BCT or Rick depends on where you look.