Torsen swap questions...

[wannafbody]

To swap a Torsen in a 91, I know I need the axle housing, axle stubs and axles, and the driveshaft. Is there anything else I need?

[— Grip Driver —]

Good time to replace the diff mounts before you put it in

[Rogue]

You can use 1pc axles too.

[wannafbody]

Any advantage to 1 piece axles vs the 2 piece axles?

[— kung fu jesus —]

To swap a Torsen in a 91, I know I need the axle housing, axle stubs and axles, and the driveshaft. Is there anything else I need?

What? Are you swapping in a Torsen or clutch type LSD from and RX7?

If it is a Torsen from another Miata, you need the pumpkin, carrier, axles and driveshaft.

[Rogue]

Any advantage to 1 piece axles vs the 2 piece axles?

Not really, I like the 2 piece so you can pull the diff without draining the oil.

[wannafbody]

I bought a 1.8 Torsen with housing to eventually swap into the 91.

[— kung fu jesus —]

Ah, ok. I like the 1pc design for simplicity, ymmv

[wannafbody]

I got a set of new cv axles and they have the ABS rings. I think that they should work fine without ABS but figured I'd ask.

[— Grip Driver —]

you can knock the abs rings off quite easily with a hammer

[wannafbody]

Is there any clearance issue with leaving them on?

[— Grip Driver —]

nope, none that I had when I did mine

[wannafbody]

Thanks