hey ya nc's
im gona start this thread... because there have been no new ones in the nc section for too long. AND i just got my fenders rolled with some interesting notes.

first off... who has their fenders bent? anyone? did you manage to get a full wheel well roll on the back? the fender roller i was using kept getting hung up on the caliper. i did not want to remove the caliper at the time so i only got a 3/4 roll.

also my rear fenders had about a 1/4 inch rubber/plastic booger layer on them. this is not a fender liner that can be unscrewed like the front. just a layer of semi-hard glop. just lay on the heat and it will bend with the metal.

speaking of fender liners, the front fender liner goes AROUND the front damper. so... get some scissors. still pops back into place the same way after cut and i have not noticed any flopping or catching since i made a cut in the fender liner.
the cut was made right behind the damper as to minimize cutting area.

so yah... no more tire string cheesey bits after canyon runs.