Hi. I am looking for a used set of Beatrush side latches. If you have it, let me know. Thanks
Hi. I am looking for a used set of Beatrush side latches. If you have it, let me know. Thanks
I haven't seen a set sold for several years now. Good luck. They do not fit well with a roll bar.
Yeah, they don't pop up used very much. However, I just installed a set in my little brother's 10AE since the Hard Dog in that car was not hardtop compatible, meaning the OE sidelatches were out of the question. They work just fine. I guess YRMV.
Last edited by WASABI; 03-23-2014 at 06:39 PM.
I've got a lot less horsepower - luckily they are Japanese horses - usually in better shape and more motivated.
Phatmiata (03-23-2014)
I was lead to believe they won't fit without modfication.
Is post #3 invisible? I think that's the sixth set I've installed, split among NAs and NBs. No problems with any of them.
I've got a lot less horsepower - luckily they are Japanese horses - usually in better shape and more motivated.
Yeah, the whole point is for use with rollbars that aren't hardtop friendly.
What doesn't work is some locking option or other. You might check that other forum for further info. There was a group buy and whatnot a few years ago, so plenty of feedback.
'90 "LE" with red bits - 7/6 Flex, FM Front Bar, 14x7 +19 RPF1, PWR, SPAL, Maxim Works, Thermal R&D, HDHCSDM2, Zoom, Anvil II, 330mm mahogany Deep Corn, AC/PS delete, LE interior, attitude
'08.5 CWP MS3 GT - AST 4100, TriPoint Rear Sway and Links, JBR STS w/ bushings and lockout plate, Moddiction Anvil II
they are designed to work better WITH roll bars, that is what they are designed for. I would follow those with some GarageStar anti-theift hardware.
Where you may run into issues with these is if you have fixed back seats mounted without sliders.
Not enough room to open them
These work very nice:
You may know me as RAB or BCT or Rick depends on where you look.
Any word on an ETA, Rick?