Pro Tips

[drv2fst]

I knew about the hole, but not about the t-bolt. Good to know !

[JLBMX5]

Need an O ring for a leaky CAS? Many hardware shops and part stores have a "box o' O rings", usually behind the counter or next to their hardware selection. The dimensions of the OEM ring is 1.5" ID x 1.75" OD, .125" Th. It goes by many part numbers, but in the standards, it is #222.

OEM is usually about $5 for one. I have bought a #222 over the counter from the Box for about $.60 - $1.

Would this o-ring be standard rubber o-ring or buna-n ? I gotta buy one and don't know what material to use

[tanakapz]

Wow, this is pretty helpful. If you remove your antenna and don't want to buy the OEM antenna plug, just use the wiper arm plug. It fits right into place and looks perfect!



looks like that piece ^

[— kung fu jesus —]

Orings... Use rubber or a heat/oil resistant material.

[— kung fu jesus —]

Good tip on the plug! Keep it going!

[Rogue]

Replacing OEM motormounts on a NA, order NBs.
There the same, and cost half what the NA ones cost.

[Andy]

Make sure the throttle cable is properly tightened. That can make a miata have much much better throttle response.

[—tsingson—]

From what I remember, when changing the fuel filter and you don't have any clamps for the lines, a couple of golf tees work perfectly to help keep that fuel off of you.

[Andy]

This was a fantastic thread idea. Any updates?

[— Agent☣Orange —]

The Nissan 370Z oil filter and shift knob will fit a Miata.