Show Mazda Roadster what you did to your NA today!
Show Mazda Roadster what you did to your NA today!
'01 NB2 aka MisF1re: http://mazdaroadster.net/showthread....218#post207218
'97 M aka Warbird, gone but not forgotten: http://mazdaroadster.net/showthread....B&goto=newpost
Instagram: @greasemonkey2000
I was bored so I decided to give something a try that I have been curious about for some time. Anyone that is a automobile enthusiast with a broad appreciation for all different makes, models and eras of automobiles have undoubtedly seen older roadsters(various other including race cars) and such with just the single windshield wiper and in fact Pit Crew did this on their car, iirc.
I have seen others do it so I knew it couldn't be difficult. As it turns out it wasn't difficult and basically you just remove both wipers and use one on the passenger side(LHD obviously) and angle it to were when the wiper is being used it wipes the majority of the driver side field of vision.
I chose to use the passenger side "wingless" since I figured it would be the least intrusive. I put it on and turned on the wiper and adjusted as needed and go it in probably half a dozen or less attempts. It is actually far less intrusive to the driver and it covers most of the driver side field of vision directly ahead. Here are some pics:
Before w/ OEM wiper setup aka boring
After w/ single passenger side wiper setup
Before w/ OEM wiper setup
After w/ single passenger side setup
Driver(s) field of vision w/ single passenger side wiper setup at rest
Driver(s) field of vision to the right w/ single passenger side wiper setup at rest
Single passenger side wiper setup @ it's lowest point of travel
View of the single passenger side wiper setup from the rear of the car
I like it but obviously the real verdict will be determined by the compromise in function when it is actually needed but a larger(another 2" or so) could be used and will check into that. I got my wife's opinion and should was indifferent at this point. If I like it I may sand it down and do a brushed type finish and clear coat it, time will tell.
'01 NB2 aka MisF1re: http://mazdaroadster.net/showthread....218#post207218
'97 M aka Warbird, gone but not forgotten: http://mazdaroadster.net/showthread....B&goto=newpost
Instagram: @greasemonkey2000
Greasemonkey2000 (01-04-2016)
did this couple days ago, just swapped my 220km dash with a jdm 180km one with matching kms.
I just like seeing the needle further up the arc, it makes me thing i'm going faster
but i broke the gauge hood whilst doing this
Installed the Revlimiter hazard/light switches, and Warbird Hvac on my tombstone. no pictures, since it's sitting on a shelf to be installed back on the car in the spring. car is... mostly inaccessible in the winter! It's killing me already, and it's been only 12 days since I put it in storage!
Installed some ebay seat skins today. Honestly kinda surprised at how well they fit/look. Also revisited the foamectomy while doing so. Sitting a little lower now in much better looking seats.
Greasemonkey2000 (02-14-2016),HarryB (01-17-2016)
radmachine (01-16-2016)
Well I've had a rather "notchy" feeling to my gear shift ever since I got my car so I ordered a rebuild kit. Only part that was missing that I really need is the guide that goes into the ball joint as its got some rather warn in marks. But otherwise it went great and I can always go back and fix it.
Oh and it turns out the smaller boot was leaking... a lot.
Last edited by BlitzWing; 01-26-2016 at 06:04 PM.
Cleaned the snow off and did a few doughnuts in the cul-de-sac on the hard pack.
The Mono-wiper Looks nice Greesemonkey!! Think I will steal your idea Could also add the Rain-X glass stuff...
I did something! Started tearing apart the interior of my Miata to install the roll bar. Going to foamectomey the seats; removed center console and going to do a diy console delete; removed the soft-top for good. I am going to make a Bikini-top. Also sanded and polished my tails and took a sharpie to the plate panel.
IMG_4500.jpg
IMG_1679.jpg
IMG_1744.jpg
IMG_1735.jpg
BlitzWing (01-27-2016),Greasemonkey2000 (01-26-2016),NCGreasemonkey (01-26-2016)
Like the artwork.
Made an air box, I'll pull it back out next weekend and paint it to match the valve cover and intake manifold. Air is getting pulled in through the wiper cowl Randall style, assuming it's working properly.
91BRG (02-14-2016),benpopham (02-14-2016),BRGNA8 (02-17-2016),Greasemonkey2000 (02-14-2016),Hammerhead (02-14-2016),JamieH (02-19-2016),NCGreasemonkey (02-19-2016),SLO NA6 (10-29-2016),WASABI (02-14-2016)
Nice work Jimmy Vee! I didn't realize yours had a rotrex supercharger, very cool!
'01 NB2 aka MisF1re: http://mazdaroadster.net/showthread....218#post207218
'97 M aka Warbird, gone but not forgotten: http://mazdaroadster.net/showthread....B&goto=newpost
Instagram: @greasemonkey2000
Jimmy we're gonna need some more details of your car, a build thread or something, coz it looks seriously cool