-
1,000 rpm - releasing the clutch
NA6 Radio blank plate / Gauge holder / failures $5 shipped in the US
I drew up some center console radio blanking plates, and had them cut with my other ABS parts recently.
I measured wrong and I'm left with a pile of 20 of these. Hair cell on 1 side, shiny on the other.
The tabs are close enough to use with screws/ washers for the DIY type person.
Be sure your center console is the type shown with 6 mounting holes.
Gauge holes are 52mm, and laser cut halfway through. The holes can be 'popped' out with a mallet and screwdriver.
Like this:
$5 shipped in the continental US. No fancy shipping here, they're going USPS standard post.
Contact me if it's got to go out of the country - I'll check postage for you.
I'll subscribe to this post, but if you're interested, paypal to
chemidlin __at__ gmail.com
REMEMBER, THESE MOUNTING HOLES DO NOT LINE UP. THIS IS FOR A DIY PERSON WHO DOESN'T MIND MODDING SOMETHING TO WORK!
IMG_7335.jpgIMG_7402.jpgIMG_7405.jpgIMG_7406.jpgIMG_7403.jpg
-
The Following User Says Thank You to vortexblue For This Useful Post:
-
1,000 rpm - releasing the clutch
14 left.
Here's a pic of the plate after someone installed one:dash block off mod.jpg
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules