HarryB (05-22-2018)
Would 110% do these in a track-only car.
oldgrayleather (05-22-2018)
Anyone have advice on a good no-weld method of sealing up the rear fenders after cutting?
Warhammer (05-24-2018)
Last edited by Warhammer; 05-24-2018 at 11:00 AM.
Paul B (05-22-2018)
RISE OLD THREAD!
It is about time to paint my NA again, and I think it might be time to put some flares on it since it spends more time on track than on the road. More meat under there is always nice.
I'm leaning toward the Jet Stream flares but I'm a little hung up because the listing on REV9 says it only adds 6mm per side but they sure look like more than that with internet/eyeball measurements. I'm hoping someone has installed a set and could give me a better idea of how much room they do or don't add.
https://rev9autosport.com/jet-stream-fender-flares.html
na_flares_2.jpg
Demon I Am (10-31-2023)
Well... 6mm was probably right. They came in. They add no additional width over my rolled and pulled stock fenders. That's disappointing. (Please excuse the skinnies)