FS: SoCal: na8 motor, nb torsens, etc.
We are currently tearing down Tony's miata, so we have parts up for sale.
---------------------------------------
94-95 Turbo "Kit"
NA8 Intercooler setup:
2.5" piping on both cold side and hot side
Cold side has pipe for IAC
Cold side has bung for IAT
Comes with all silicons and t-bolt clamps
Designed for HKS manifold with t25/28
^no AC/PS
Blitz Blow Off Valve
-New Venturi Drive
Intercooler
^Core 21.5" x 9.5"
^^Overall 28" x 9.5"
Turbo 3" downpipe
-custom 2piece
--v-band setup
-no divorce
Turbo 3" exhaust setup
-fully custom
--two resonators
---quiet large muffler
--electronic exhaust cutout
Only parts needed to complete the turbo setup of how it was originally on tony's car are:
--t25/t28 turbo
--HKS manifold
Original cost of parts:
Aluminum Intercooler Pipes: $350
Intercooler: $100
BOV: $200
Downpipe: $300
Exhaust piping: $150
Resonators: $150
Muffler: $60
Electronic Cutout: $150
Total: $1460
Price: TBA
----------------------------------------
5spd transmission
Still bolted to engine
Will pull when bought
$250 OBO
----------------------------------------
6spd transmission
-was going into the car after rebuild
--change of plans
---unsure of condition, but should be good
$800 OBO
----------------------------------------
Torsen rear-end Type 2
-2002 SE
--4.3 gear
---Complete with axles and driveshaft
--off the drift-car, heavily used
$700 OBO
----------------------------------------
Torsen Type 2
-unknown year
-unknown gearing
-complete with axles and driveshaft
-backup set (swap for another miata)
$800 OBO
----------------------------------------
na8 motor
-off Tony's car
--Ran GREAT
---Never any problems
--Timing belt/water pump 8k
-140k, 50k boosted
--ACT Clutch and Flywheel
---6 puck sprung Heavy Duty
---Prolite 10.4lb
---^8k with 2 drift events
--NGK Power Cable set
-oil pan tapped for turbo
$700 OBO
----------------------------------------
MSPNP for 94-95 NA8
-off Tony's car
$550 OBO
550CC Red-top Injectors
$150 OBO
Both: $600 OBO
----------------------------------------
OEM Hood with pins
-Rustoleum paint
$75
----------------------------------------
OEM Fenders
-rolled and pulled
--to fit 16x8 et0 w/ 205-40-16
-Rustoleum paint
--includes fender markers
$150 for both
----------------------------------------
9998 by terry pham, on Flickr
----------------------------------------
Pictures of all parts at:
http://www.flickr.com/photos/terrypham/
----------------------------------------
If you want more than one part, we can make a deal.
