-
-
-
6,000 rpm - mere mortals would shift
you'll need to completely remove the tombstone piecs, and the crash pad, then glass in a bridge piece to fill in the missing bit. From there, you could remove and cut out the lower half of the dash, adding in a custom center support (like the one above). You could also opt to keep the lower dash and cut/glass/build a short version of te tombstone (to keep ac/radio)
-
-
2,000 rpm - light wheelspin, no bog here!
i know what to do lol, (ill have the dash completely out) im just asking how do i "glass in a bridge piece"?
-
-
1,000 rpm - releasing the clutch
Expanding foam will fill it in and can be shaped with ease.
Once you have the desired shape, lay on some aluminum foil and glass right over.
After the glass sets, scoop out the foam which should come right off due to the aluminum foil.
BTW. That is one nice dash in that second picture.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules