So I'd like to preface this review with this: I'm a fabricator, and study engineering. I've been around machining and custom metal fab for a good while, and I know quality work when I see it.
So about a month ago I decided I was going to build a custom exhaust for my car using lightweight materials. I was really adamant about having a high flowing, lightweight exhaust system on my car, that had a deep, throaty (HAHA! I said deepthroat) sound. After searching through numerous videos on youtube, this video really caught my attention.
After hearing that, I looked at the enthuza XR system. Looking on the site, I tried to figure out what he was using to get that kind of sound out of the car.
After looking into it, with me buying mandrel bent pipe pieces, flanges, mufflers/resonators, tips, and round bar in order to build my system, I was over the cost of an enthuza setup!
So I called up Jason at enthuza and we talked, I asked him about all the things i'd cover when building my exhaust, welding, bending, materials etc. I was very impressed with his responses and decided to jump in and order an exhaust. Today, my exhaust arrived.
The exhaust was wrapped up very well, but UPS raped the box along the way, there were holes in my box, parts of it were ripped. See the condition of the box when I got it scared me. But, when I opened it everything seemed ok.
Everything was fine except for the midpipe being bent in a little on the end where it connects to the axle back. No big deal, threw a pipe expander in it and made it round again.
As I started to unwrap the exhaust I immediately noticed the welds, they were beautiful. All of it was TIG.
Heres what it looked like once completely unwrapped.
Part 2 will be posted tomorrow once I get it on the car ;)