Much easier than that. Valve cover was wire brushed (on the end of a cordless drill), then washed - that's it. Duplicolor Metalcast red and then after full cure, clear engine enamel. Wet sand and polish the clear.
I did grind off the "16 DOHC..." lettering off one side of the valve cover. Gives it a longer appearance, much different with the cut valve cover.
WASABI (05-15-2014)
it looks really coolOriginally Posted by Jumbosrule
Much easier than that. Valve cover was wire brushed (on the end of a cordless drill), then washed - that's it. Duplicolor Metalcast red and then after full cure, clear engine enamel. Wet sand and polish the clear.
I did grind off the "16 DOHC..." lettering off one side of the valve cover. Gives it a longer appearance, much different with the cut valve cover.
Last edited by WASABI; 06-15-2014 at 02:09 AM.
Posting Permissions
Reply With Quote